|
www.iJDMTOY.com
Installation DIY
Guide for Japanese or American Car LED license plate lights (168 or 194 LED
bulbs)
Step 1:
There are two
bulbs that you
will need to
replace and they
reside in these
two grey
housings. Each
bulb receives
it's power from
the white
connector.
Step 2: Each
housing is held
in place by 2
clips (found on
the left and
right side of
the white
connector).
Step 3: Pinch
these two clips
inwards to
release the
housing.
Step 4: Release
the housing from
the power
connection. The
white connector
has a little
wedge thing that
needs to hold
down with thumb.
Step 5: Replaced
the OEM 168/194
light bulb with
T10/T15 LED
bulb.
Step 6: After
having the LED
bulb installed,
Connect the
power supply
back to the
housing. Test it
before putting
the housing back
into the trunk,
if the LED bulb
doesn't light
up, simply take
the LED bulb out
and flip it 180
degrees to
correct the
polarity.
Step 7: Enjoy
the new light!
Thanks to
8thCIVIC Forum,
for original
post, please
check
here.
|
