How to use T-taps to install load resistors for LED turn signal lights.
Step 1: Get a pair LED load resistors and a pair of Quick Tap Connectors (red ones showing in the picture), you can easily find the T-tap from any local electronics store such as Radio Shack, Fry's, etc. You will also need a pair pliers for the installation.
Step 2: Insert the Quick Tap Connector to the LED bulb wire and also the load resistor wire
Step 3 : Close the Quick Tap Connectors using the pliers
Step 4 : Do the same for the other side
Step 5 : Make sure to mount the load resistors to metal since it will get hot
Final: Test the LED turn signal lights and enjoy it