This installation is based on a 2007 BMW E90 328i and covers how to install CAN-bus error free 6418 LED bulbs for license plate lights. This DIY guide
applies for most BMW such as 1 3 5 7 Series, X5 and X6. This shows you how to pop/remove the factory license plate lamp...(read more)
Get rid of the ugly egg-yolk look with iJDMTOY's super bright high power LED turn signal light bulbs! Not only our LED bulbs 2x brighter than
stock, but they are also 100% error free for some of the most popular BMW cars such as E90/E92 3 Series, F10 5 Series, E70 X5 and E71 X6.
Installation is very easy, simply plug and play.There is no modification required, no adding external resistor required...(read more)
This DIY guide is based on a 2009 Mercedes W204 C-Class and covers how to replace stock W5W bulbs with LED for license plate lamps. This
installation procedure is very standard for most Mercedes-Benz that requires removing the trunk liner in order to access the license plate light bulb...
For some tricky cars like 2013+ Volkswagen GTi, there aren't any CAN-bus LED bulbs that work 100% yet. Because of this, we have developed
these add-on CAN-bus decoders for the W5W LED bulbs so they will work 100%! Here we will show you how to install these decoders...(read more)
Take a look at this video, we are showing you our specially designed CAN-bus 3156 LED bulbs on a 2008 Mercedes W204 C300 for the front turn signal lights. These
specially designed 3156 LED bulbs function 100% error free, and also allow you to install LED bulbs for turn signal lights without the annoying hyper flash problem.
We are going to show you how to install the CAN-bus error free 2825 W5W LED bulbs for a Mercedes-Benz E-Class for parking lights. Please remember that
after the installation once you verified the LED bulbs light up, always turn off all the lights and lock the car for 5 sec to reset the OBC. This is so you won't see any false-positive error
message pop up...(read more)
CAN-bus Error Free Get Rid of Error Messages
Many modern 21st century European cars such as Audi, BMW, Mercedes-Benz, Volkswagen, etc, all come with on-board computer systems that will detect when and where a light bulb is not properly functioning or burned-out. Since LED bulbs naturally have less power draw on the system, many European vehicles see this as a fault and as a result, a "bulb-out" error message appears.
Since 2008, we have come out with a solution for you: CAN-bus error free LED bulbs. This class of CAN-bus LED bulbs has either built-in load resistors or a magnified inductor to raise up the total wattage so they can “fool” most Audi, BMW or Mercedes-Benz's on board computers without triggering an error or bulb out warning on the dashboard.
Here at iJDMTOY, we carry a large selection of CAN-bus error free LED bulbs in sizes such as W5W, H6W, C5W, PW24W, P21, W21W, etc for parking position lights, daytime running lights, license plate lights, backup reverse lights and turn signal lights. You can use our CAN-bus LED bulbs to light up your European cars error free and worry free.
Tips for installing the CAN-bus Error Free LED bulbs
Always do the installation with the engine off and key out of the ignition with the light is off
After installation, the first thing you need to do is to make sure the LED bulbs do light up
If the LED bulb does not light up in step 2, try to flip the LED bulb 180-degrees
Once you are sure both LED bulbs light up, then turn off the lights, lock the car for 5-10 seconds to reset the on board computer to make sure there is no more
false-positive error message