30" 150W High Power CREE LED Light Bar with Hidden Lower Bumper Mounting Bracket and On/Off Switch Wiring Kit For 2016-up 3rd Gen Toyota Tacoma

Q: Will this LED light bar fit my truck?

A: This LED light bar is compatible with the 2016-up Toyota Tacoma.

Q: Is there any modification required for installation?

A: No, there is absolutely no modification required for installation. The iJDMTOY LED light bar is unlike Rigid, where the latter requires cutting prior to installation.

Q: Is this LED Light Bar water resistant?

A: The LED light bar is rated at IP67 waterproof, meaning that you can use the assembly under any weather condition. However, we don't recommend submerging the LED light bar under water and please try not use a high pressure water jet to spray directly on it either.

Q: What if I don't want to take off my front grille before installing the LED light bar?

A: Sorry. Taking off the front grille is required for installing the LED light bar. You can see that there's not enough space to insert the LED light bar if the grille is still attached.

Q: How do I know which mounting holes to use to secure the Toyota Tacoma LED light bar?

A: To find out which mounting holes to use, remove the bumper and look at the crash beam facing the front side. Because you will be installing this onto a 2016 or later Toyota Tacoma, you will be mounting your metal mounting brackets onto the inner mounting location by the support bracket's 2nd hole. The Toyota Tacoma should have 2 mounting holes on the outer side of the crash beams.

Q: Why does my LED light bar not sit in the middle of the gap?

A: If the LED light bar is set straight in the middle, the light will be blocked by the plastic beams and bar. We designed our mounting brackets so that the LED light bar sits just below the plastic bar to prevent any light obstruction.

Q: How come when I connect the LED light bar to power, it does not light up? or part of the LED light bar does not light up? or part of the LED light bar does not light up as bright as the other part(s)?

A: The LED light bar is polar sensitive so if the LED light bar does not light up at all, please try to switch the two wires around and try again.

For any "part" light up/flickering, or "part" is not as bright as the other half issues, it indicates the power source is not strong enough to completely power up this high power LED light bar. It happens especially when you are testing the LED light bar with a 12V power supply (normally can only power up to 60W) or could mean your car battery is not fully charged or the battery is too old that does not hold enough "juice" anymore.