This installation guides applies for 70-876 OEM Turn Signal Lamp Replace LED Daytime Running Light Kit Compatible With 2015-2017 Ford Mustang (Xenon White LED DRL w/ Amber Sequential Signal Feature)
Step 1) Begin the installation process by removing the front wheel well plastic cover, disconnecting all wires, and removing the necessary screws to detach and remove the entire turn signal/fog lamp assembly from the bumper.
Step 2) Carefully detach and completely remove the entire turn signal/fog lamp assembly out once all screws have been removed.
Step 3) Proceed to remove the remaining screws in order to separate the OEM turn signal lamp from the signal/fog assembly.
Step 4) Refer to the provided picture comparing the OEM and our iJDMTOY full LED DRL/Sequential Blink Turn Signal, as you can see it is a direct replacement capabilities with identical adapters with extended wiring for an easily installation.
Step 5) Install the full LED DRL/Sequential Blink Turn Signal onto the signal/fog assembly, following the same procedure used to remove the OEM unit.
Step 6) In order to prevent the LED turn signal from hyper flash, you need to plug in the load resistors and make sure to mount the load resistor to the metal chassis of the vehicle since it will get very hot in use.
Step 7) Reinstall all components back and repeat the process on the other side.